I have just got a large Razor strop fungus to make a razor strop. Might sound like a stupid question, but i take it its just a case of drying it, cutting in into a rectangle and gluing in to a board?
steve
steve
I have made a couple. Dried the fungus first and then cut with a saw. I was not too impressed with them as they seemed too soft with too much give in them. I think they were 5 mm thick, 65mm by 100mm
I can not remember where, but I am sure I read that they were often pressed, after being cut.
Kepis how did you cut yours and how thick and what size?
How did you cut yours Mark?