Last Wednesday I had a bit of a tidy up at work and then decided to write the rest of the day off and make this from the scraps of flooring and leftover bits of ironmongery that's been kicking around for quite some time.
It is based on the Veritas plans I'd seen but as I did not have a full set of dimensions some head scratching was required.
My plank was only 28mm thick so I ran a groove into another piece to take the threaded bar. This also meant adding a hinge block to allow
the front leg to fold flat. The brass fitting is a catch for box sash windows and locks the leg brace in place.
[video]https://youtu.be/4YnAjXxIQc8[/video]
[video=youtube;4YnAjXxIQc8]https://www.youtube.com/watch?v=4YnAjXxIQc8[/video]
Cheers for looking in and thanks for those who tried before and have popped back, google photo is pants, btw
Rob.
It is based on the Veritas plans I'd seen but as I did not have a full set of dimensions some head scratching was required.
My plank was only 28mm thick so I ran a groove into another piece to take the threaded bar. This also meant adding a hinge block to allow
the front leg to fold flat. The brass fitting is a catch for box sash windows and locks the leg brace in place.
[video]https://youtu.be/4YnAjXxIQc8[/video]
[video=youtube;4YnAjXxIQc8]https://www.youtube.com/watch?v=4YnAjXxIQc8[/video]
Cheers for looking in and thanks for those who tried before and have popped back, google photo is pants, btw
Rob.
Last edited: