I have managed to stretch my woeful electronics knowledge to put this battery pack and lead combination together for my Fuji X10
That was straight forward as the DC coupler required 5V and there was a 5V output on the pack.
Now looking at the pack I can see that there is a 9V and a 12V output socket as well.
I cannot help but wonder if there is a way to use the 9V socket to run my Canon SLR but the DC coupler for the Canon needs between 7.4V to 8V.
How do I go about reducing a DC voltage from 9V to the right amount? I presume it's not just as simple as just putting a resistor into the circuit?
That was straight forward as the DC coupler required 5V and there was a 5V output on the pack.
Now looking at the pack I can see that there is a 9V and a 12V output socket as well.
I cannot help but wonder if there is a way to use the 9V socket to run my Canon SLR but the DC coupler for the Canon needs between 7.4V to 8V.
How do I go about reducing a DC voltage from 9V to the right amount? I presume it's not just as simple as just putting a resistor into the circuit?