Login

Partners

Bushcraft Ventures 
Bushcraft Expeditions 
Dryad Bushcraft 
Greenman Bushcraft 
Wildside Survival 
Woodcraft School 
Woodsmoke 
 
The Ties That Bind and The Bindings That Tie Print E-mail
Written by Norm Kidder   
Article Index
The Ties That Bind and The Bindings That Tie
Page 2
Page 3

Review of Binding Material

1. Whole Vines, Roots and Shoots - Whole vines, roots and willow branches can be used in many crude binding situations. They have the disadvantage of being round, and often stiff. If dry, they are brittle, if green, they shrink while drying (in diameter, not length) and loosen. A stiff, round cross-section limits the surface area in contact and therefore the friction. If stiff, contact may not be continuous, further reducing the friction surface and ability to pull tight. These work best tying bundles of soft material such as grass or reeds that compress easily, increasing friction surface and conforming to uneven bending. Their greatest advantage is lack of preparation time, just cut and use.

2. Willow Wythes - Increased flexibility is achieved with whole shoots by twisting the stems back and forth around their axis. This separates the individual fibers and lets the wythe act like a piece of single ply cordage, with greatly increased friction.

3. Bark Strips - Willow, maple, basswood and many other woody plants have bark that can be stripped off in long strips when the sap is flowing. These ribbon like strips are normally much stiffer than cordage, but being flat have a large friction surface and can be very strong when tied with appropriate binding techniques. When stripping single pieces, they tend to get smaller as you pull. I find it best to cut a stick about an inch in diameter and peel the whole thing at once into two strips. I can further split these down later. Bark strips can be dried and re-soaked, which also makes them a bit less prone to loosening through shrinkage than when used green. Some barks can also be separated into layers, increasing the quantity and usability of the material. Bark bindings will become quite stiff when dry, making it difficult to retighten them, but reducing the chance they will come loose even after shrinking.

4. Split Shoots - Many woody materials are split for use in basketry. In the west, willow, redbud, sedge roots, spruce and pine roots, and buck brush to name a few can be split into halves or thirds, then the harder central section further split out to leave the flat and flexible cambium layer for binding. This is usually stronger than bark, and can be preshrunk by drying and soaking if time permits. This is excellent for long term projects, but may be time consuming for quickie, disposable applications and takes a bit of practice to perfect.

5. Reeds and Grasses (and other stringy leaves and stems) - With few exceptions, reeds, sedges and grasses are not very strong, but may be sufficient for quick tying of bundles for transport. They are best used when cut and wilted (partially dried to a leathery feel). This happens naturally to reeds attacked by muskrats or insects, so check out the stand for yellow colored stems. All these materials become much stronger when twisted into one or more ply cordage.

6. Yucca-type Leaves - The long, straight, and somewhat flat leaves of some agaves, yuccas and their relatives, New Zealand flax, and a few similar leaves can be used much like bark strips. Agaves are usually too flat unless they have dried out, and also may contain irritating juice. These may be used whole or split depending on their shape and state of dryness. When time is available to process them, they can produce progressively finer cordage.

7. Single Ply Cordage - Single ply refers to a bunch of fibers, either separated (like rope) or in a soft matrix (like reeds) which is uniformly twisted around an axis (either clockwise or counter-clockwise). Twisted fibers do not receive strain along their length, but at an angle, giving them some stretch. This elasticity allows them to take up shock gradually, reducing the risk of breaking. Also, as the separate fibers rub against each other, this friction helps equalize the load, allowing them to work together. In untwisted cordage, strain builds up in the shortest fiber first, until it breaks, then the next, and so on. Disadvantages include more time to make than some of the above and a strong tendency to unravel if not in use. Good for fixed bindings but not for fish lines, nets, or bowstrings, etc.

8. Two Ply Cordage - Two ply is made by wrapping two single plies around each other in the opposite direction of the twist in the plies (both plies must be twisted the same direction). This counter twist creates friction between the plies, holding them tightly together, and limiting unraveling to the ends. This cordage is the strongest in almost all situations (except for three-ply, which is really hard to make by hand).

9. Braided Cordage - Braiding (or plaiting as it is sometimes called) involves diagonal weaving of three or more strands. Braiding is slower to do than thigh rolling two-ply cordage, but is usually done with flat leaves (cattail, juncus, etc.) which require little preparation. Also, the braid can be kept flat, making it more suitable for some applications than round cordage. As with all flat binding material, it requires different lashing techniques than flexible round cordage, but has more surface area for increased friction.

10. Rawhide - Cut strips of rawhide (babiche to French Canadian trappers) bound together snow shoes, drums, houses, clothing, basket rims, and many other items. It has some big advantages and disadvantages. On the plus side: it's easy to make in quantity anywhere large animals are hunted; when it's wet it is very flexible and takes knots well; when it dries it shrinks in both diameter and length, making it self tightening; and in a pinch, you can eat it. Negatives: mice eat it; when it gets wet, it stretches; when dry, it tends to be brittle; when it gets wet, it stretches (I'm repeating this for emphasis).

11. Leather (braintan of course) - Similar to rawhide except that it doesn't shrink up as tight, nor get as stiff and brittle when dry.

12. Sinew - Sinew is the connective tissue that attaches an animal's muscles to its bones. It is very strong and fine. It is used for thread, to make bowstrings, and strengthen the backs of bows. It is good for making arrows, etc., but like rawhide, it may come loose if it gets wet. It is a bit tricky to knot.

13. Animal (including human) Hair - Hair varies greatly in strength, length, texture and usability. Curly hairs spin into the best yarn, while very straight hair wants to slip apart. In primitive skills applications, this is not a likely option (unless you're in Mt. Goat country in the spring). Single human hairs are recorded as quail snares.

 



 

Latest Articles

Photography - Back to Basics (08.12.2008)

thumb_k10d.jpg We all love to take photographs and keep a record of what we've done and where we have been.  Michelle Jones  has written this article is for those starting out into photography so that you can get the most from your camera and what you are trying to capture.

Back to Basics is about getting more from your outdoor experience by increasing your skills in an area you might not have thought of before.

Fish Trap (01.04.2008)
thumb_fishtrap9.jpgI used Hazel wood. Choose the thin long shoots of wood which i would think are a couple of years old. If you don't catch anything at first don't worry. It may just be a case of changing a few things.
Birch Tar - How to collect it (23.02.2008)
thumb_tar13.jpg Most bushcrafters know that Birch bark is fantastic for fire lighting because of all the oil concealed within it. This tutorial guides you through the process of extracting that tar from the bark.
Wild Wine (Part 8) (28.11.2007)
thumb_wildwine6.jpgNow we could bung a label on (which should always say they type of wine and when it was bottled). I suggest you cross-reference to a book of recipes and notes so that when you get a cracking wine you can recreate it. We are going to add a little something to the presentation of the wine by putting a foil cap over the neck. First we drop a foil cap (available for a couple of pence from a wine shop) over the bottle neck.
Wild Wine (Part 7) (26.11.2007)
thumb_wildwine1.jpgRight, we now have clean, fined and filtered wine. We pour it into clean (yes and sterilised) bottles with a funnel. We need to cork it. Its possible to put corks in with a mallet. I use a corking gun and waxed corks that do not need to be soaked (plain corks do)
Wild Wine )Part 6) (23.11.2007)
thumb_wildwine1.jpgWell, the finings have worked – the wine is beautifully clear.

Most Popular Articles

Paracord Bracelet Tutorial (23.04.2007)
thumb_paracordbracelet16.jpgAs soon as I'd finished my Paracord Bracelet, I'd decided to write a tutorial on making one. A good thing considering the majority of the responses since I posted it were asking me how to do it! Here goes.. You will need approximately 3 metres of paracord with the ends already sealed/melted, and something to make a temporary knot - a twist tie or piece of string should suffice.
Tarps - Benefits and Basic Instructions (16.07.2007)

thumb_tarp1.jpgWhy a Tarp? In my quest to lighten my backpack I considered and, at first, rejected the use of a tarp instead of a tent. I liked the idea of a tarp, after all there are great advantages like....

How to Sharpen an Axe (09.07.2007)
thumb_axesharpening21.jpgI have been asked a number of times recently to provide some advice of guidance on the best way to sharpen an axe. Whilst I am always happy to provide input, I thought that it might be worthwhile to put together a tutorial on the basic techniques. The techniques used in here are intended to provide not only a sharp axe but also a safe and efficient axe.
Bannock (05.04.2007)
thumb_bannock1.jpg There was a period in my life where I lived out of a pack for months at a time and this was one of my staples. I like to coil it like a rope on a stick and bake it over hot coals...
Berry Picker (23.04.2007)
thumb_berrypicker10.jpgThere are many different ways you can make a berry picker but this is just a design i came up with which uses a packet of kebab skiewers and some discs of wood.
Fire By Friction - Using a fire-kit made with stone tools (31.05.2007)
thumb_firefrictionwhitcombe2.jpgThe whole kit took less than three hours to finally pull together — though that really overlooks by far the most time-consuming aspect, the preparation of materials. In fact, preparation has two components, actually. The first is the selection of materials. The second is the actual preparation.