|
Written by Storm
|
As a matter of ritual, I engage in hand drill and fireplow everyday. One aspect of each that has bothered me in the past is that these techniques have traditionally required the participant to bend over and stress one's back muscles, of which I have significantly damaged in the past.
For the hand drill, I always sit while doing it, thus avoiding further injury and pain (but tremendously increasing the difficulty of succeeding). For fireplow, I've long wanted to develop a method in which my back is better supported. Finally I've met success!
 |
 |
I've been practicing one-armed fireplow, very occasionally, for a couple years. I hadn't sincerely committed to practicing it until this summer. After two months of daily practice, I made my first ember last week (I made an ember using this method a number of years ago, but I don't recall the woods I used, and it was an isolated incident) using CA Fan Palm on Sotol. So far, I've been able to generate an ember about once in every ten tries. That will improve over time as I increase my level of fitness (for the past month I've eaten nothing but sprouts--that I grow myself, oatmeal, dried fruit and nuts, raw fruits and veggies, and the occasional can of salmon...nature power! How long does it take to lose 100 pounds?).
Calling it "one-armed" is a bit of a misnomer, because I use one arm on the plow (see how I hold it in the pics above) and one arm holding the base still. There are paleolithic ways of securing the base, of course. But "one-armed" is appropriate in order to distinguish this method from all others--everyone uses two arms on the plow, but this hurts my back almost immediately. So far, I seem to consistently produce a plow trench 10-12cm long. |
Using one arm to hold the base allows me to support my back a bit by leaning on that arm. I've also been using
(but no embers yet) bamboo and mule fat plows. I don't think the bamboo will work--it burnishes the sotol base quickly, but one-armed bamboo-on-bamboo is coming close to succeeding. I will post videos of this technique on my website as soon as I get a memory card for my digital camera (it's expensive).
|
Storm
Copyright ©2003-2007 Bushcraftuk.com
 |
Show/Hide comments
Show/Hide comment form
BushMoot, the best event of the year - from 1st -5th August 2008 at Merthyr Mawr in South Wales. 
I used Hazel wood. Choose the
thin long shoots of wood which i would think are a couple of years old.
If you don't catch anything at first don't worry. It may just be a case of
changing a few things.
Most bushcrafters know that Birch bark is fantastic for fire lighting
because of all the oil concealed within it. This tutorial guides you
through the process of extracting that tar from the bark.
Now we could bung a label on (which should always say they type of wine and when it was bottled). I suggest you cross-reference to a book of recipes and notes so that when you get a cracking wine you can recreate it. We are going to add a little something to the presentation of the wine by putting a foil cap over the neck. First we drop a foil cap (available for a couple of pence from a wine shop) over the bottle neck.
Right, we now have clean, fined and filtered wine. We pour it into clean (yes and sterilised) bottles with a funnel. We need to cork it. Its possible to put corks in with a mallet. I use a corking gun and waxed corks that do not need to be soaked (plain corks do)
Well, the finings have worked – the wine is beautifully clear.
As soon as I'd finished my Paracord Bracelet, I'd decided to write a tutorial on making one. A good thing considering the majority of the responses since I posted it were asking me how to do it! Here goes.. You will need approximately 3 metres of paracord with the ends already sealed/melted, and something to make a temporary knot - a twist tie or piece of string should suffice.
I have been asked a number of times recently to provide some advice of guidance on the best way to sharpen an axe. Whilst I am always happy to provide input, I thought that it might be worthwhile to put together a tutorial on the basic techniques. The techniques used in here are intended to provide not only a sharp axe but also a safe and efficient axe.
There was a period in my life where I lived out of a pack for months at a time and this was one of my staples.
I like to coil it like a rope on a stick and bake it over hot coals...
There are many different ways you can make a berry picker but this is just a design i came up with which uses a packet of kebab skiewers and some discs of wood.
The whole kit took less than three hours to finally pull together — though that really overlooks by far the most time-consuming aspect, the preparation of materials. In fact, preparation has two components, actually. The first is the selection of materials. The second is the actual preparation.