PDA

View Full Version : Crab/Lobster pots



Pignut
16-04-2006, 09:43
I have a load of wire mesh from a chipmunk run I once made and am now looking into making a lobster/Crab pot for holidays at the coast etc

Is it legal to trap these or is a permit required?

Is there any special technique is it possible from the beach

Marts
16-04-2006, 10:21
I have a load of wire mesh from a chipmunk run I once made and am now looking into making a lobster/Crab pot for holidays at the coast etc

Is it legal to trap these or is a permit required?

Is there any special technique is it possible from the beach

This recent thread might have some useful info for you mate :)

http://www.bushcraftuk.com/community/showthread.php?t=12037

Sorry about quoting your whole message, but it was the only way I could find to get around the current security problems and actually post!!

Pignut
16-04-2006, 10:37
Thanks for that!

Don't know how i missed that on my search

Pignut
18-04-2006, 13:17
Does anyone know how to make a prawn/Crab pot can it be done with wire mesh?

Don Redondo
18-04-2006, 15:09
the old way would be with hazel

otherwise; make a frame some 24" x 18" out of some bits of wood 2"x1" would do. . leave some gaps in the frame. fill these with concrete. drill 6 1" holes in the outer long side of the frame [each corner and middle]. get 3 x 11/2" rods of green hazel and steam bend them into arcs whittle ends down and push into holes. clad in mesh all round. buy cheap kids bucket and cut off bottom. cut hole in mesh. stitch bucket into mesh narrow end inwards. attach rope and buoy [milk carton]. bait up with something smelly. throw in water. watch local lobstermen get angry.

alternatively look on ebay for plastic prawn pots.

Pignut
18-04-2006, 20:37
the old way would be with hazel

otherwise; make a frame some 24" x 18" out of some bits of wood 2"x1" would do. . leave some gaps in the frame. fill these with concrete. drill 6 1" holes in the outer long side of the frame [each corner and middle]. get 3 x 11/2" rods of green hazel and steam bend them into arcs whittle ends down and push into holes. clad in mesh all round. buy cheap kids bucket and cut off bottom. cut hole in mesh. stitch bucket into mesh narrow end inwards. attach rope and buoy [milk carton]. bait up with something smelly. throw in water. watch local lobstermen get angry.

alternatively look on ebay for plastic prawn pots.

LOL dont wat to upset the locals!